Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES User Manual
Product codes
WNDAP360-PES
Installation and Basic Configuration
19
ProSafe Dual Band Wireless-N Access Point WNDAP360
Configure Basic General System Settings and Time Settings
Note:
After you have successfully logged in to the wireless access point,
the basic General system settings screen
displays.
To configure basic system settings:
1.
Select Configuration > System > Basic > General. The basic General system settings
screen displays:
screen displays:
Figure 8.
2.
Specify the fields as explained in the following table:
3.
Click Apply to save your settings.
Table 2. Basic General System Settings
Field
Description
Access Point Name
This unique name is the wireless access point NetBIOS name. The name is printed
on the rear label of the wireless access point. The default is netgearxxxxxx, where
xxxxxxx represents the last 6 digits of the wireless access point MAC address. You
can replace the default name with a unique name up to 15 characters long. The
access point name can be retrieved through SNMP.
on the rear label of the wireless access point. The default is netgearxxxxxx, where
xxxxxxx represents the last 6 digits of the wireless access point MAC address. You
can replace the default name with a unique name up to 15 characters long. The
access point name can be retrieved through SNMP.
Country/Region
From the Country/Region drop-down list, select the country where the wireless
access point is installed.
access point is installed.
Note:
It might not be legal to operate this wireless access point in a region other than
one of those identified in this field.