Netgear DUALBAND WLAN WNDAP360 N300 AP WNDAP360-PES User Manual

You cannot configure wireless bridging when automatic channel 

selection is enabled. On the basic Wireless Settings screen, make 
sure that Auto is not selected from the Channel / Frequency 
drop-down list (see 

on page 23).

Configure a Point-to-Point Wireless Network

In point-to-point bridge mode, the wireless access point communicates with another 
bridge-mode wireless station. Use wireless security to protect this communication. The 
following figure shows an example in which two wireless access points (APs) function in 
point-to-point bridge mode:



Select the 802.11b/bg/ng or 802.11a/na tab.

Configure the wireless access point (AP1 on LAN Segment 1 in the previous figure) as a 
point-to-point bridge:

a. Select Configuration > Wireless Bridge. The Bridging screen displays (see the 

following figure).

b.  Select the Enable Wireless Bridging check box. The Local MAC Address field is a 

nonconfigurable field that shows the MAC address of the wireless access point.

c.  Select the Wireless Point-to-Point Bridge radio button. The screen adjusts.