Rigol DS1074Z-S 4-channel oscilloscope, Digital Storage oscilloscope, DS1074Z-S Data Sheet
Product codes
DS1074Z-S
RIGOL
DS1000Z User’s Guide
6-33
Track Mode
In this mode, one or two pairs of cursors will appear. You can adjust the two pairs of
cursors (cursor A and cursor B) to measure the X and Y values on two different
sources respectively. The points being measured on cursor A and B are marked by
and
respectively. When the cursors are moved horizontally, the marks will
position on the waveform automatically. When the waveform is expanded or
compressed horizontally, the marks will track the points being marked at the last
adjustment of the cursors.
Press Cursor Mode “Track” to turn on the cursor track function and the
measurement results will be displayed at the upper left corner of the screen in the
following mode.
compressed horizontally, the marks will track the points being marked at the last
adjustment of the cursors.
Press Cursor Mode “Track” to turn on the cursor track function and the
measurement results will be displayed at the upper left corner of the screen in the
following mode.
The X value at cursor A (AX): take the trigger position as reference and “s” or
“Hz” (when measuring FFT waveform) as its unit.
The Y value at cursor A (AY): take the channel GND as reference and use the
same unit as the current source.
The X value at cursor B (BX): take the trigger position as reference and “s” or
“Hz” (when measuring FFT waveform) as its unit.
The Y value at cursor B (BY): take the channel GND as reference and use the
same unit as the current source.
The horizontal difference between cursor A and B (BX-AX).
The vertical difference between cursor A and B (BY-AY).
The reciprocal of the horizontal difference between cursor A and B (1/|dX|).
If needed, please refer to the following steps to modify manual cursor track
measurement parameters.
The vertical difference between cursor A and B (BY-AY).
The reciprocal of the horizontal difference between cursor A and B (1/|dX|).
If needed, please refer to the following steps to modify manual cursor track
measurement parameters.