Greisinger EB 3000 Display, control and monitoring device EB 3000 - 603291 Data Sheet

E35.0.01.6C-03                     Manual for connection and operation of the EB 3000                        page 17 of 19

Here are 2 essential settings:

  - By measurement channel the 

-measurement channel with identification number is shown, which

is allocated to the respective channel. Until 20 channels can be listed. Measurement channels can also be
multiple listed and you can change the order of sequence as you like, so that by cyclic display (adjustable in
the control box on the top left-hand corner) any cyclic illustration flow is reachable.
Reselection resp. modification of the left shown attached 

-measurement channels results via „drag

and drop“ or by activation of the right mouse button.
Hint: „----„ means that no measurement channel is allocated and this channel will not be monitored.

  - By timeout the minimum updating-rate of the measurement channels in seconds will be specified (adjust-

able between 8,0 and 50,0 seconds). If a updating of the  measurement value of the respective measure-
ment channel within the specified time-interval will not be possible (resp. overload of bus capacity), an error
message will be displayed (timeout-error).
Hint: For fully occupied measurement system choose timeout duration not too low, to avoid error messages
of the measurement system.

  - auxiliary display „channel description“ for the respective channel shown in the auxiliary display. The

input of the „channel description“ can be 2-digit, both letters and numbers are accepted.
Hand-over of the channel description causes via click outside of the input folder resp.
by pushing the enter-key. If the decimal point next to the channel description of the
auxiliary display illuminates, cyclic operation is adjusted.
Hint: please note, because of the restricted possibility of the 7-segment-display not all
letters can be indicated.

  - main display

measurement value of the respective channel.
For actualisation push button „refresh“ beyond this column.

  - LED‘s

you can allocate one or more „unit-LED’s“ to each measurement channel. The 
4 „unit-LED’s“ are on the front side of the EB3000 on the right side next to the main
display. This settings are binary coded (for example by setting value 3 illuminates
LED 1+ LED 2). A click with the right mouse button on the respective value opens
dialogue window „edit unit-LED‘s“.

  - display enduranceduration time in seconds, how long this channel will be indicated by cyclic display

(max.25,5s).
Hint: there is no relationship between display endurance and channel monitoring. For
example by setting display endurance = 0 the respective channel will not be displayed
but he will be monitored.