Gigaset E45 S30852-H1751-R203 User Manual

Gigaset E45 / English / A31008-M1751-R201-1-SM19 / start_guide_time.fm / 04.08.2005

If the handset does not activate automati-

cally when the battery pack is fitted, you 

must first charge the battery pack. 
You must activate manual registration of 

the handset at both the handset and the 

base station. 
After it has registered, the handset returns 

to idle status. The handset's internal 

number is shown in the display e.g. 

. 

If not, repeat the procedure.

v

¢

Ð

¢

¢

s

Select base station, e.g. 

, and press 

§OK§

.

~

Enter the system PIN of the 

base station (the default is 

0000) and press 

§OK§

. The 

screen will display, e.g. 

 

.

Within 60 secs. press and hold the regis-

tration/paging key on the base station 

(page 1) (approx. 3 secs.). 

You can connect the following types of 

headset (with jack connector): HAMA 

Plantronics M40, MX100 and MX150.
If you do not connect a headset, please 

insert the cover supplied for the headset 

socket to guarantee the unit is still splash 

proof.

¤

Plug the mains adapter of the charging 

cradle into a mains power socket.

¤

Place the handset in the cradle with its 

display facing forward. 

To charge the battery pack, leave the 

handset in the charging cradle. If the 

handset is activated, the flashing battery 

icon 

e in the top right of the display indi-

cates that the battery pack is being 

charged. During handset operation, the 

battery icon indicates the charge status of 

the battery pack (page 1).

The correct charge status can only be dis-

played if the battery pack is first fully 

charged and discharged. 

¤

To do this, leave the handset in the 

charging cradle continuously for ten 

hours. Your handset need not be 

switched on for it to charge. 

¤

Afterwards, remove the handset from 

the charging cradle and do not put it 

back again until the battery pack is fully 

discharged. 

u Always repeat the charging and dis-

charging procedure if you remove the 

battery pack from the handset and 

insert it again.

– Automatic registration is not possible when 

the base station on which you wish to reg-

ister the handset is being used to make a 

call. 

– Each key press interrupts the automatic 

registration.

– If automatic registration does not work, 

you will have to register the handset manu-

ally.

– The handset should only be placed in a 

base station or charging cradle that is 

designed for it.

– When the handset is in the cradle, it 

charges even if it is switched off. 

– If the handset has switched itself off 

because the battery pack is flat and it is 

then placed in the cradle, it will switch itself 

on automatically.

– After the first battery charge and discharge 

you may replace your handset in the charg-

ing cradle after every call.