Mueller electrical installation 873020 Leaflet
Product codes
873020
BA 873020cfl N;DE,GB -23248- 2013.01-V01 - ED
INSTRUCTION MANUAL DIMMER [CFL]
Technical Features
Safetey instructions
Supply voltage
230 V, 50Hz
CAUTION!! DANGER OF LIFE / RISK OF FIRE AND ELECTRIC SHOCK!!
Installation and assembly of electrical equipment must be carried out only by professional electrician!
Connect the supply voltage/frequency as stated on the product!
Disconnect device from power supply for wiring and installation purposes! Check power supply is disconnected!
Defective devices have to be put out of service immediately!
Warranty void if housing opened by unauthorised person!
The electronic circuit is protected against a wide range of external influences.
Incorrect operating may occur if external influences exceed certain limits!
Installation and assembly of electrical equipment must be in accordance with local building and electrical codes!
Power consumption
3 VA
Suitable type of lamps
Dimmable Compact Fluorescent Lamps
Load
20 – 200 W
Dimensions
45 x 45 x 12 mm
Weight
40 g
Permitted ambient temperature
0º … +40ºC
Storage temperature
-30º … +70ºC
Type of protection
IP20 according to DIN EN 60529
Conformity with Standard
DIN EN 60669-2-1
Description / Installation / Operation
Wiring Diagram
Description
Small size dimmer, for flush-mounting (e.g. behind standard pushbutton)
For leading dimming.
Protected against overload and short circuit. Built-in heat protection.
Controlled by pushbutton.
With or without memory.
Suitable for dimmable Compact Fluorescent Lamps with built-in ballast (Dimmable CFL’s)
Installation
1 Disconnect installation from power supply and check that power supply is disconnected.
2 Install the dimmer according to the wiring diagram.
3 Make sure the loads are connected properly and reconnect power supply.
4 The dimmer is ready for use.
Operation
Press shortly the pushbutton to switch the lamps on and off!
=> Switch on „No Mem“ = Lamp(s) switches on with max. brightness.
=> Switch on „Mem“ = Lamp(s) switches on with the brightness of the last switch off
With a long press you can dim!
(*) It is recommended to install the neutral
wire in order to avoid flickering or
malfunctioning.
Example: