Eurochron EFWS 90 i Wireless Weather Station TE368NL+TS01 Data Sheet

(

Insert the batteries in the outdoor sensor first and only then into the weather
station. This applies as well if you have more than one outdoor sensor
(available as accessories).
During commissioning, the outdoor sensor should be nearby the weather
statio0n (within 1 m distance).
Also maintain a distance of at least 1 m to other devices (e.g. TV, computer,
phone) and metal parts (e.g. radiator). This ensures that the weather station
recognises the outdoor sensor correctly.

—

Open the battery compartment (19) on the outdoor sensor’s rear by pushing
the battery compartment lid downwards slightly so that it can be taken off.

—

Insert two batteries of the type AAA/micro with correct polarity into the battery
compartment of the outdoor sensor (observe plus/+ and minus/-).

—

Close the battery compartment again.

—

The included bracket (20) can be used as wall bracket and base. It can be pushed
on at the top, bottom and on the rear of the outdoor sensor, depending on desired
assembly site.

(

The outdoor sensor is suitable to be used in a protected outdoor area. It
should be placed so that it is not subject to direct solar irradiation or rain/
snow, because measured values may otherwise be incorrect.
When installing the outdoor sensor, ensure that the battery compartment
points down so that no water may enter.

Never immerse or submerge the outdoor sensor in water; it would be
destroyed!

(

The weather station can receive and display the measured data of up to 3
outdoor sensors. Each outdoor sensor must be registered on a different
transmission channel.
The included outdoor sensor is firmly set to channel 1; this cannot be changed.
The outdoor sensors available as accessories have a channel selection switch;
set it to channel 2 or 3.