Eurochron EFWS 600 Wireless Weather Station WSA903 +THX301 Data Sheet

As already described in chapter 11, it may be necessary to set the time and date
manually if the DCF reception is bad.
For the manual setting as well as for the DCF reception the 12/24 hour display, the
sequence of day and month on the display and the language for the display of the
abbreviation of the weekday can be selected.

(

If the DCF reception is active, simply skip the setting of the time and date
(don’t change anything). Below, you will find out how to do this.

—

You have to be in the normal time display mode (no alarm display). If necessary
press the time key 

 (1) several times, until the time is displayed.

—

Press the time key 

 (1) for about 2 seconds until a tone signal can be heard.

The current mode (12 or 24 hours) flashes on the display (”12h” or ”24h”).

—

Adjust the mode with the ”” or ”” key.

(

If no key is pressed for 10 seconds the current setting is copied and the
setting mode is exited. The current time is displayed again.

—

By briefly pressing the time key 

 (1) you will change to the next setting step.

—

The hour display flashes.

(

Please note: If the DCF reception was active beforehand, it is switched off
when the time is adjusted!

—

Set the hours with the ”” or ”” keys, if so desired. If the respective key is
pressed for a longer period of time, quick adjustment is performed.

(

If no key is pressed for 10 seconds the current setting is copied and the
setting mode is exited. The set time is displayed.

—

By briefly pressing the time key 

 (1) you will change to the next setting step.

—

The minute display flashes.

(

Please note: If the DCF reception was active beforehand, it is switchd off
when the time is adjusted!

—

Set the minutes with the ”” or ”” keys, if so desired. If the respective key is
pressed for a longer period of time, quick adjustment is performed.
When adjusting the minutes the seconds are automatically set to ”00”.

(

If no key is pressed for 10 seconds the current setting is copied and the
setting mode is exited. The set time is displayed.

b) Fonction répétition d’alarme (« SNOOZE »)
Quand le signal de réveil se déclenche à l’heure programmée, vous pouvez par un
mouvement de la main devant le capteur IR (A) activer la fonction de répétition d’alarme.

(

La distance entre main et capteur IR devrait être environ de 8 à 10 cm maximum.

Le signal de réveil est ainsi interrompu pour environ 5 minutes puis retentit de nouveau.
Ceci est possible plusieurs fois (9 fois)

c) Arrêter le signal de réveil
Afin d’arrêter le signal de réveil, appuyez soit sur la touche « ALARM » (5), «  », «  »
soit sur la touche de l’heure 

 (1).

Le signal de réveil retentit le jour suivant à la même heure.
Pour désactiver l’alarme (par. ex. au week-end), procédez ainsi que décrit au chapître
13. a).