C&E S3318P Wireless Weather Station S3318P Data Sheet

The barometric pressure display on the weather station changes with the altitude of the site
of setup. The barometric pressure values you will get, e.g. online, are always referring to sea
level. Therefore, you may adjust the display.
Proceed as follows:
• Get the current barometric pressure at your place of residence, e.g. online.
• Push the „BARO“ button (9) for about 2 seconds until the barometric pressure display (C)

flashes.

• Set the barometric pressure value with the buttons „BARO“ (10) or „BARO“ (11) (for

quick adjustment, keep the respective button pushed).

• Briefly press the button „BARO“ (9) to terminate setting mode.

Weather Station:
Push the button „MAX/MIN °C/°F“ (4) for 3 seconds to switch between the temperature unit °C
(degrees Celsius and °F (degrees Fahrenheit).
Outdoor Sensor:
To switch the outdoor sensor display between °C and °F, briefly push the button „°C/°F” (15)
in the battery compartment of the outdoor sensor.

The weather station can receive the temperatures measured by up to 3 outdoor sensors and
display them (one is included in the delivery, two more can be ordered as accessories).



Every outdoor sensor must be set to a different transmission channel (1, 2 or 3). The
slider for this is in the outdoor sensor battery compartment.

When more than one outdoor sensor is logged on to the weather station, push the button
„CHANNEL“ (5) several times to display the measured values of the respective outdoor sensor.
The weather station display shows the channel number (Q) of the currently selected outdoor
sensor.
When an arrow „

“ (P) is displayed additionally below to the channel number, the weather

station automatically switches between the displays of all outdoor sensors logged on after a
few seconds.
Order when pushing the button „CHANNEL“: CH1 -> CH2 -> CH3 -> 

 -> CH1......