Gigaset C475IP ECO DECT S30852-H1917-M101 User Manual

Gigaset C470/C475 / Grossbritannien / A31008-M1902-L101-1-7619 / appendix.fm / 6.8.07

Ve

rs

ion 4,

 16

.09.

2005

¤

Wipe the base station, charging cradle 

and the handset with a damp cloth (do 

not use solvent) or an antistatic cloth. 

Never use a dry cloth. This can cause a 

build up of static. 

If the handset has come into contact with 

liquid:
1. Switch the handset off and remove 

the batteries immediately.

2. Allow the liquid to drain from the hand-

set.

3. Pat all parts dry, then place the handset 

with the battery compartment open 

and the keypad facing down in a dry, 

warm place for at least 72 hours 

(not in a microwave, oven etc.).

When it has fully dried out, you will nor-

mally be able to use it again.

If you have any questions about using 

your phone, visit us at 

at any time. The table below contains a list 

of common problems and possible solu-

tions.

The display is blank. 
1. The handset is not turned on.

¥

Press and hold the end call key 

a

.

2. The battery is flat.

¥

Charge or replace the batteries 

pressed.
The keypad lock is activated.

¥

Press and hold the hash key 

#

 

"Base station x" flashes on the display.
1. The handset is outside the range of the 

base station.

¥

Move the handset closer to the base sta-

tion.

The base station's range is reduced because 

eco mode is activated.

¥

Deactivate eco mode (page 13) or 

reduce the distance between the hand-

set and the base station.

2. The handset has been deregistered.

¥

Register the handset (page 40).

3. The base station is not turned on.

¥

Check the base station's mains adapter 

Base Search flashes in the display. 
No base station turned on or in range.

¥

Move the handset closer to the base sta-

tion.

¥

Check the base station's mains adapter 

Handset does not ring. 
1. The ringer tone is switched off.

¥

Activate the ringer tone (page 47).

2. Call diversion set to 

¥

Deactivate call diversion (page 18).

the fixed network. 
The phone cord supplied has not been used or 

has been replaced by a new cord with the 

wrong jack connections.

¥

Please always use the phone cord supplied 

or ensure that the jack connections are cor-

rect when purchasing from a retailer 

Error tone sounds after system PIN prompt.
You have entered the wrong system PIN.

¥

Reset the system PIN to 0000 (page 49).

¥

Reset the system PIN to 0000 (page 49).