Futaba 6J F4103 Data Sheet

Dual Rates/Exponential Settings vary slightly between the airplane (ACRO) mode and the helicopter (HELI) 
mode.  As such, the information pertaining to these functions will be separated into ACRO and HELI 
sections below.  Please adhere to the section that pertains to the model for which you are programming the 
T6J transmitter.

# ++ {ˆ|# +# #    
affecting the overall travel of the servo(s).  Thus, decreasing the percentage value for a given servo will 
reduce the travel amount of the channel respectively.    

For example, if the elevator of the aircraft travels 1/2” at the high rate and maximum stick input, and a value 
of 50% is input for the low rate, when the switch is moved to the low rate position, the servo moves exactly 
half as far per stick position.  Following this example, if the elevator control input is all the way up, the 
maximum travel is now 1/4” 

The T6J transmitter offers dual rates on the aileron, elevator and rudder channels.  The dual rates are 
assignable to any of the switches on the transmitter and all are simultaneously activated by the dual rate 
switch selected.  

The amount of travel decrease for each control may be set between 0% and 140% of the values set for the 
end points (explained in End Point Adjustment on page 33).

Note: It is possible to set a dual rate value to zero, thus causing no response from that channel when the dual 
rates are activated.  If the dual rates are inadvertently set to zero, a crash could result.

Note:!## !%<*  #+ ! # 
%<*   '##  #+ ‘]]š

Prior to programming the dual rates for the aileron, elevator or rudder channels, we suggest selection of the 
switch that will be utilized to control the rate settings.

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.

3) Press either the MODE key OR the END key to scroll through the function menus.  Each time one of the 

aforementioned keys is pressed the menu will change accordingly. Continue pressing the MODE or END