Futaba 6J F4103 Data Sheet

key until the dual rates (D/R) menu appears on screen. 

4) Press the SELECT key three (3) times to scroll past the channel settings to access 

the switch selection options.

5) Press the DATA INPUT lever either upward or downward until the desired switch 

selection appears onscreen.  

6) Next, press the SELECT key one time to proceed to adjust the dual rates.

1) Press the SELECT key to choose the desired channel (1-aileron, 2-elevator, 4- rudder). The channel 

number appears on the left side of the screen.

2) Place the dual rate switch (selected previously) in the desired position for the value you wish to change.  

;;!  ## ' ! # ’ˆ
arrow is pointing upward, the rate is being adjusted for the up position of the switch.

 ^## !# ! '{!|! {'|! 

for the low rate.

3) Change the dual rate value for the respective channel using the DATA INPUT lever until the desired 

control throw is achieved.  If you wish to change the control throw when the switch is in the other position 
as well, move the switch accordingly, then use the DATA INPUT lever to change the throw rates.

4) Repeat the procedure for the remaining channels as desired.  

5) Press and hold the END button to save these settings and exit the programming menu.

Exponential, or EXPO as it is commonly abbreviated, affects the travel of the servos around their center in 
relationship to stick movement.  Exponential does NOT impact the overall travel volume of the servos.  A 
!  &!# {›|            }#~  " !  ;   
! !#  #'##+ " #! 
 # {${&!#!'##  } ~} ~# 
neutral position.  

The T6J transmitter offers exponential adjustments for the ailerons, elevator and rudder channels.  The EXPO 
settings are controlled by the switch that has been selected for the dual rates (D/R).  As with the dual rates 
settings, the exponentials are also simultaneously activated.