Futaba 6J F4103 Data Sheet

The T6J transmitter defaults to the normal wing type (non-selectable).  If your model uses a single servo to 
control the ailerons, there is nothing more to do.  If, however, you are using separate servos to control each 
aileron individually, please activate the Flaperon mixing.  Information on how to do so is contained in the 
section that follows.

The ability to use separate servos to function in the same 
   #  =! =   '" 
!!   #  "' =! * 
function allows the ailerons to be used both as ailerons and as 
=! 

Flap control is assigned to Channel 6, the proportional rotary knob on the front of the transmitter.  As such, 
=!  # +  ##=!#*# ##
course, by the aileron stick accordingly.

Note: A trim input on the aileron channel will move the two wing servos in the opposite direction.  If so 
desired, sub-trim must be input for the two wing servos individually as it impacts the servos rather than their 
function.    

1) Turn the transmitter on.

2) Press and hold the MODE button to access the programming mode.

3) Press either the MODE key OR the END key to scroll through the function menus. 

Continue pressing the MODE or END key until the flaperon (FLPR) wing menu 
appears on screen. 

4) Push the DATA INPUT lever upward for approximately two (2) seconds.  This will 

 [‹ !# = !# += >[ !# 

Note:€    {?#!| & ' {%#| &   #  +       +#
{?#!|&   #{%#|&‹' ##' {?#!|
{Œ$#|& # # 

5) Connect the aileron servo in the right wing to channel 1 (aileron) in the receiver and connect the aileron 

#'#}=! ~

*If necessar y, use the Ser vo Reversing 
function to achieve the correct direction of 
servo throws.