Futaba 6J F4103 Data Sheet

percentage of rudder travel rates.  The available adjustments are between -100% and 
›‘]]š

8) Once this mix has been activated, move the servos to their full extremes to make 

certain they are not overdriving the controls.  If necessary, adjust the linkages to 
achieve the correct control throws.  

Note: It is important to ensure that no binding occurs when providing full elevator and full rudder inputs.  
This will maximize the inputs from both channels and provide you with the worst-case scenario.

9) Press and hold the END button to exit the programming menu.

  ##  {=  '| #      # ' 
and flying wings, elevon mixing mixes channel 1 (aileron) to 
channel 2 (elevator) allowing the elevons to operate in unison (as 
elevators) or in opposition (as ailerons).  This function requires 
that each elevon be operated by a separate servo.

Note: The Elevon function can not be utilized when either the 
Œ$;#  ?#!       Œ$#  =!  
activated, it will not be possible to activate the elevon mixing 
function.

1) Connect the servo in the right wing channel to channel 2 (elevator) in the receiver and connect the servo in 

the left wing to channel 1 (aileron) in the receiver.

2) Turn the transmitter on.

3) Press and hold the MODE button to access the programming mode.

4) Press either the MODE key OR the END key to scroll through the function menus.  

Continue pressing the MODE or END key until the elevon (ELVN) menu appears 
on screen.

 €    {%#| & ' {?#!|  {Œ$;’| &   # 

+ +#{%#|&   #+{?#!|
{Œ$#|&

*If necessary, use the Servo Reversing 
function to achieve the correct direction of 
servo throws.