Futaba 6J F4103 Data Sheet

3) Press either the MODE key OR the END key to scroll through the function menus.  

Continue pressing the MODE or END key until the throttle curve (T-CV) menu 
appears on screen.

4) The right side of the LCD should indicate that the throttle curve is inhibited, as 

 +   =  [‹ *  #  +  !   #
 ˆ*;* [<‚; # !'  ; [‹  # + =  !#  ! 
changing to ON.  

5) Press the SELECT button six (6) times to bring up the (SW) switch selection 

options.  

Note: it is possible to assign the throttle curve operation to any of the switches on the T6J.

6) Press the DATA INPUT lever upward or downward to select the desired switch for the throttle curve that 

will be programmed below.

Note: Prior to adjusting the throttle curve points, ensure that the switch is in the desired position (up or 
down).   

1) From the activation channel selection screen above, press the SELECT button two 
(2) times.  This will bring up point one (1) of the throttle curve programming.  The 
current value is expressed, in percentage of the overall throttle travel, in the lower 
right portion of the LCD. 

2) Press the DATA INPUT lever upward to increase the percentage of servo travel for the respective point on 
the throttle curve.  

3) Press the SELECT button one time to bring up the point two (2) throttle curve adjustments.  Again, use the 
DATA INPUT lever to adjust the values accordingly.

4) Repeat the steps above as desired for the remaining three points on the throttle curve.

5) Press and hold the END button to exit the programming mode.

In addition to the throttle curve, the T6J also offers a pitch curve in the airplane functions.  This will allow 
modelers to utilize variable pitch propellers in their aircraft.