Futaba 10J F4109 Data Sheet

13

(Specifications and ratings are subject to change without notice.)

• T10J transmitter for airplanes or helicopters

• R3008SB Receiver 

• Switch harness 

• Neck strap
*The set contents depend on the type of set.

(2-stick, 10-channel, T-FHSS Air-2.4G system) 

Transmitting frequency: 2.4GHz band

System: T-FHSS Air,  S-FHSS, switchable 

Power supply: 6.0V Dry battery

(T-FHSS Air-2.4G system, dual antenna diversity, S.BUS system)

Power requirement: 4.8V~7.4V battery or regulated output from ESC, etc. (*1)

Size: 0.98 x 1.86 x 0.56 in. (24.9 x 47.3 x 14.3 mm)

Weight: 0.36 oz. (10.1g)

Battery F/S Voltage: It sets up with a transmitter

(*1) When using ESC's make sure that the regulated output capacity meets your usage application.

The voltage can be displayed at the transmitter by branch connecting the drive battery, etc. installed in 

the fuselage with the CA-RVIN-700 cable sold separately.

The 10J is a 2.4GHz T-FHSS Air system. The transmitter can also be switched to S-FHSS. (However, the telemetry 

system cannot be used with S-FHSS.) The usable receivers are shown below.

*The Futaba T-FHSS Air system cannot be used with Futaba S-FHSS/FASST/FASSTest systems. Use 

it with a T-FHSS Air system transmitter and receiver. The T10J is a T-FHSS Air system, but can also 

be used with an S-FHSS receiver by switching to S-FHSS. However, in this case the telemetry system 

cannot be used.

*The T-FHSS Air system and T-FHSS surface system are different. The T10J cannot be used with the 

R304SB, R304SB-E or T-FHSS surface system receivers.