Futaba 10J F4109 Data Sheet

① Call the menu screen from the 

home screen by pressing the + 

key for 1 second.

＋

② Select 

    from the menu with the 

Jog key.

③ Open the setting screen by 

pressing the Jog key.

（1 second）

This function sets the operating motor when 

the EP glider with motor is started by switch. The 

operating speed can individually set in 2 ranges 

of high from slow and slow from high. If you do 

●For safety, the ON/OFF switch of the aircraft itself 

can be set.

●If a transmitter power supply is switched on while 

the  motor  SW  has  been  ON,  the  warning  will 

operate.  Be sure to switch on a power supply with 

the motor-start switch OFF.

● Select the setting 

item  with  the 

Jog key.

＋

－

or

① Select the "MODE" item 

and  then  select  the 

"OFF" by pressing the 

+ key or – key.

● When you do not use a function, set to the 

"INH" side. 

＋

－

or

② Change the switch by 

pressing the + key or 

–  key  at  the  switch 

selection item.

Range：SwA ～ SwH

＋

－

or

③ S e l e c t   t h e 

"DOWN"  item 

and then select 

the position by 

pressing the + key or – key.

● 2P SW： UP, DOWN

● 3P  SW： UP, UP&D, UP&C, CNTR, 

④ Select "SPEED " next to (OFF) and (ON) by Jog key.

Range：OFF,1 ～ 10(more slowly)
●

is the acceleration speed setting.

●

 is the deceleration speed setting.

● Start SW

● Accelerating speed setting

● Decelerating speed setting

● If this safety switch is not ON, the 

motor will not start even if the 

starter  switch  is  turned  on.  In 

"NULL", a safe function does not 

work.

● A  setup  of  the  motor  control 

position (3CH end point)of High-

side and Low-side

● Present motor control position

Always remove the propeller from the motor during setting and at operation checks.
■There is the danger of the propeller spinning unexpectedly and causing a serious injury.