Futaba 10J F4109 Data Sheet
Product codes
F4109
174
TX SETTING
The settings here are special settings that are unnecessary during normal use. The stick mode can be
changed and stick adjustment (calibration), throttle lever reverse, and language can be set.
changed and stick adjustment (calibration), throttle lever reverse, and language can be set.
■ STK-MODE
■ STK-ADJ
Turn on the power switch with the + key
and – key pressed in the power off state. The
screen shown at the left appears. To return
to the home screen, turn off the power
and then turn the power back on without
pressing the keys.
and – key pressed in the power off state. The
screen shown at the left appears. To return
to the home screen, turn off the power
and then turn the power back on without
pressing the keys.
This is the MODE1 〜 MODE4 setting. The
initial state is MODE2. To change the mode
the stick ratchet must be changed. Request
that this be done by Futaba Service. (Charged
modification)
initial state is MODE2. To change the mode
the stick ratchet must be changed. Request
that this be done by Futaba Service. (Charged
modification)
This function is normally not used. If stick deviation should occur, make this adjustment.
Do not use it in the normal state.
Do not use it in the normal state.
THR
ELE
RUD
AIL
MODE 1
ELE
THR
RUD
AIL
MODE 2
THR
ELE
AIL
RUD
MODE 3
ELE
THR
AIL
RUD
MODE 4
① Turn off the power and then
turn the power back on while
pressing the + key and – key
simultaneously.
② Select STK-ADJ → NEXT
in the menu with the Jog
key.
③ Enter the setting screen by
pressing the Jog key.
Calling the setting screen
+
-
① Select the stick you want to
adjust with 1 〜 4 with the +
key.
+
② Press the Jog key down
and select NEUT ■ .
③ Set the stick to the neutral
position and press the Jog
key.
Stick adjustment
2
3
4
1
TX SETTING
English
STK-MODE
1
STK-ADJ NEXT
THR-REV
NOR
LANGUAGE