Futaba 10J F4109 Data Sheet

33

 This set uses the S.BUS/S.BUS2 system. The wiring is as simplified and clean mounting as 

possible, even with models that use a large number of servos. In addition, the wings can be 

quickly installed to the fuselage without any extraneous wiring by the use of only one simple 

wire, even when there are a large number of servos used.

●When using S.BUS/S.BUS2, special settings and mixes in your transmitter may be unnecessary. 

●The S.BUS/S.BUS2 servos memorize the number of channels themselves. (Settable with the T10J)

●The S.BUS/S.BUS2 system and conventional system (receiver conventional CH used) can be mixed.

S.BUS　Glider usage example

S.BUS Aerobatic  plane usage example

Receiver: R3008SB

Battery: FR2F1800 ( Optional )

Switch: HSW-L

Throttle servo: BLS173SV ( Optional )

Aileron servo: BLS174SV×2 ( Optional )

Elevator servo: BLS173SVi×2 ( Optional )

Rudder Servo: BLS175SV×1 ( Optional )

HUB×3 ( Optional )

 

Receiver: R3008SB

Servo: S3173SVi×9 (Optional)

i Connector (Optional)

i-i Connector (Optional)

i-i Connector (Optional)

i-i Connector (Optional)

HUB×1 (Optional)

* i-i Connector makes S.BUS connection 

of  SVi servo to SVi servo.

* i Connector makes S.BUS 

connection of  SVi servo to receiver.