Futaba 10J F4109 Data Sheet

36

S.BUS/S.BUS2 servos or a telemetry sensor can be connected directly to the T10J. Channel 

setting and other data can be entered for the S.BUS/S.BUS2 servos or sensors. 

3-way hub 
or Y-harnesses

(S.BUS/S.BUS2  

Servo)

S.BUS/S.BUS2 

device

(Telemetry sensor)

Receivers

Battery

Back of T10J

1. Turn on the transmitter power.
2. Call the setup screen.
　

Servo:  → S.BUS LINK → MODE IN

　

Sensor:  → SENSOR → REGISTER

3. Connect the S.BUS device and battery you 

want to set with a 3-way hub or Y-harnesses 

as shown in the figure.

4. Perform setting in accordance with each 

screen.

5. This sets the channel and other data for each 

S.BUS servo, or telemetry device to be used 

with the S.BUS device or receiver.