Futaba 10J F4109 Data Sheet
Product codes
F4109
42
Common function
① Select the LINK item and then press the Jog key
for 1 second.
(1 second)
● T-FHSS Air only. S-FHSS does not enter the link
mode. Use the receiver link button to link the
receiver.
② Enters the link mode for about 20 seconds.
During this time, bring the receiver near the
transmitter and turn on the receiver power.
When linking, the receiver ID is displayed.
● In the link mode, a confirmation "beep
b e e p b e e p " s o u n d s a n d t h e t i m e
remaining is displayed on the screen.
When 20 seconds have elapsed, a
continuous beep sounds and the link
mode is exited.
For safety, linking must not be performed while the drive motor or engine is running. When linking is
complete, turn the power off and on and check operation.
Link
① Select the RX item and then select
T-FHSS Air or S-FHSS by pressing
the + key or – key.
+
-
or
Selection range:T-FHSS Air,
S-FHSS
● Confirmation message
"sure?" blinks.
② RX type change by pressing the
Jog key.
● A c o n f i r m a t i o n " b e e p "
sounds is complete.
For safety, a double setting system is used. When a change is cancelled after the confirmation message is
displayed, the change is not made when moved to another setting item by Jog key.
RX type
*Link is required when a new model is made from a model selection.