Futaba 10J F4109 Data Sheet

①  Call  the  menu  screen  from  the 

home screen by pressing the + key 

for 1 second.

＋

② Select 

    from the menu with the Jog 

key.

③  Open  the  setting  screen  by 

pressing the Jog key.

（1 second）

The End Point function adjusts the left and right 

servo throws, generates differential throws, and 

will correct improper linkage settings.

●The servo travel can be adjusted individually at 

the left and right sides.

At 100% setting the servo throw of each channel is about 40° 

for channels 1 to 4 and about 55° for channels 5 to 10.

However, the maximum servo travel for channels 5 to 10 is 

about 110%.

*When channels 5 to 8 were mixed by flaperon, differential or 

ailvator, the throw becomes the same (about 40° ) as channels 

1 to 4.

● Select the channel with 

the Jog key.

● The  setting  rate  of  each 

channel

（Left ／ Down）

rate display

（Right ／ Up）

rate display

①  A channel is chosen by Jog key.

②  Operate the stick or knob of the selected 

channel fully to the left (down) or right (up) 

and adjust the rate by pressing the + key or 

– key.

or

● When  you  want  to 

return the set value 

to  the  initial  value, 

press the + key and – 

key simultaneously.

Adjust the rate of each direction of the stick and VR by repeating step ① .

1: AIL（Aileron） 6: FLP（Flap）1: AIL（Aileron） 6: PIT（PITCH）1: AIL（Aileron） 6: FL2（Flap2） 1: AIL（Aileron） 6: AUX

2: ELE（Elevator）7: AUX

2: ELE（Elevator）7: AUX

2: ELE（Elevator）7: AL2（Aileron2）2: ELE（Elevator）7: AUX

3: THR（Throttle）8: AUX

3: THR（Throttle）8: AUX

3: MOT（Motor） 8: FL3（Flap3） 3: THR（Throttle）8: AUX

4: RUD（Rudder）9: AUX

4: RUD（Rudder）9: AUX

4: RUD（Rudder）9: FL4（Flap4） 4: RUD（Rudder）9: AUX

5: GER（Gear） 10: AUX

5: GYR（GYRO） 10: AUX

5: FLP（Flap）

10: AUX

5: MOD

10: AUX

＋

－