Futaba 10J F4109 Data Sheet

①  Call  the  menu  screen  from  the 

home screen by pressing the + key 

for 1 second.

＋

② Select 

    from the menu with the Jog 

key.

③  Open  the  setting  screen  by 

pressing the Jog key.

（1 second）

The following functions can be set for programmable mixing 1 to 4:

● Use this function by changing the channel because the master channel and slave channels initial setting is a 

temporary combination. 

● When OFS was selected as the master channel, the mixing rate setting applies to slave only. When a mixing 

rate is set, slave servo operation is offset by that amount.

● A knob (VR) or digital trim (DT5, DT6), as well as a channel, can be selected as the master channel.

● Whether or not mixing includes master channel trim operation can be selected.

● The master channel mixing reference point can be shifted.

● The programmable mixing ON/OFF switch can be selected. The switches that can be selected are switches A to 

H and the throttle stick. 

● The switch operating direction can be set. When a 2 position switch was selected, up /down can be set, and 

when a 3 position switch was selected, up/up and down /up / and center/center/center and down /down can 

be selected. When the throttle stick was selected, the ON/OFF position and operation direction can be set. 

When "NULL" is selected, mixing is always ON.

Programmable mix 5 to 6 allows setting of the mixing rate by 5 point curve.

OFS and knob/digital trim use and trim selection by normal type master channel setting described 

above are impossible, but switch selection is possible.

Mixing that can independently customize 6 

functions can be used. Programmable mixing is 

used to remove bad tendencies of the aircraft and 

make operation pleasant. In addition to mixing 

between arbitrary channels, this function includes 

linking   (linking with another mix), trim addition, 

offset, and switch setting functions.