Microchip Technology MCU PIC PIC18F87K22-I/PTRSL TQFP-80 MCP PIC18F87K22-I/PTRSL Data Sheet
Product codes
PIC18F87K22-I/PTRSL
PIC18F87K22 FAMILY
DS39960D-page 276
2009-2011 Microchip Technology Inc.
20.4.7
PULSE STEERING MODE
In Single Output mode, pulse steering allows any of the
PWM pins to be the modulated signal. Additionally, the
same PWM signal can simultaneously be available on
multiple pins.
Once the Single Output mode is selected
(CCPxM<3:2> = 11 and PxM<1:0> = 00 of the
CCPxCON register), the user firmware can bring out
the same PWM signal to one, two, three or four output
pins by setting the appropriate STR<D:A> bits
(PSTRxCON<3:0>), as provided in
PWM pins to be the modulated signal. Additionally, the
same PWM signal can simultaneously be available on
multiple pins.
Once the Single Output mode is selected
(CCPxM<3:2> = 11 and PxM<1:0> = 00 of the
CCPxCON register), the user firmware can bring out
the same PWM signal to one, two, three or four output
pins by setting the appropriate STR<D:A> bits
(PSTRxCON<3:0>), as provided in
While the PWM Steering mode is active, the
CCPxM<1:0> bits (CCPxCON<1:0>) select the PWM
output polarity for the Px<D:A> pins.
The PWM auto-shutdown operation also applies to the
PWM Steering mode, as described in
CCPxM<1:0> bits (CCPxCON<1:0>) select the PWM
output polarity for the Px<D:A> pins.
The PWM auto-shutdown operation also applies to the
PWM Steering mode, as described in
. An
auto-shutdown event will only affect pins that have
PWM outputs enabled.
PWM outputs enabled.
REGISTER 20-4:
ECCPxDEL: ENHANCED PWM CONTROL REGISTER
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
R/W-0
PxRSEN
PxDC6
PxDC5
PxDC4
PxDC3
PxDC2
PxDC1
PxDC0
bit 7
bit 0
Legend:
R = Readable bit
R = Readable bit
W = Writable bit
U = Unimplemented bit, read as ‘0’
-n = Value at POR
‘1’ = Bit is set
‘0’ = Bit is cleared
x = Bit is unknown
bit 7
PxRSEN:
PWM Restart Enable bit
1
= Upon auto-shutdown, the ECCPxASE bit clears automatically once the shutdown event goes
away; the PWM restarts automatically
0
= Upon auto-shutdown, ECCPxASE must be cleared by software to restart the PWM
bit 6-0
PxDC<6:0>:
PWM Delay Count bits
PxDCn = Number of F
OSC
/4 (4 * T
OSC
) cycles between the scheduled time when a PWM signal
should
transition active and the actual time it does transition active.
Note:
The associated TRIS bits must be set to
output (‘0’) to enable the pin output driver
in order to see the PWM signal on the pin.
output (‘0’) to enable the pin output driver
in order to see the PWM signal on the pin.