Microchip Technology IC PIC MCU PIC18F65J15-I/PT TQFP-64 MCP PIC18F65J15-I/PT Data Sheet
Product codes
PIC18F65J15-I/PT
© 2009 Microchip Technology Inc.
DS39663F-page 351
PIC18F87J10 FAMILY
27.2
DC Characteristics:
Power-Down and Supply Current
PIC18F87J10 Family (Industrial)
PIC18F87J10 Family (Industrial)
PIC18F87J10 Family
(Industrial)
(Industrial)
Standard Operating Conditions (unless otherwise stated)
Operating temperature
Operating temperature
-40°C
≤ T
A
≤ +85°C for industrial
Param
No.
Device
Typ
Max
Units
Conditions
Power-Down Current (I
PD
)
(1)
All devices
27
69
μA
-40°C
V
DD
= 2.0V
(5)
(Sleep mode)
43
69
μA
+25°C
121
149
μA
+85°C
All devices
49
104
μA
-40°C
V
DD
= 2.5V
(5)
(Sleep mode)
69
104
μA
+25°C
166
184
μA
+85°C
All devices
75
203
μA
-40°C
V
DD
= 3.3V
(6)
(Sleep mode)
100
203
μA
+25°C
140
289
μA
+85°C
Note 1:
The power-down current in Sleep mode does not depend on the oscillator type. Power-down current is measured with
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
the part in Sleep mode, with all I/O pins in high-impedance state and tied to V
DD
or V
SS
, and all features that add delta
current disabled (such as WDT, Timer1 oscillator, BOR, etc.).
2:
The supply current is mainly a function of operating voltage, frequency and mode. Other factors, such as I/O pin loading
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all I
and switching rate, oscillator type and circuit, internal code execution pattern and temperature, also have an impact on
the current consumption.
The test conditions for all I
DD
measurements in active operation mode are:
OSC1 = external square wave, from rail-to-rail; all I/O pins tri-stated, pulled to V
DD
;
MCLR = V
DD
; WDT enabled/disabled as specified.
3:
For RC oscillator configurations, current through R
EXT
is not included. The current through the resistor can be estimated
by the formula Ir = V
DD
/2R
EXT
(mA) with R
EXT
in k
Ω.
4:
Standard, low-cost 32 kHz crystals have an operating temperature range of -10°C to +70°C. Extended temperature
crystals are available at a much higher cost.
crystals are available at a much higher cost.
5:
ENVREG tied to V
SS
, voltage regulator disabled.
6:
ENVREG tied to V
DD
, voltage regulator enabled.