Texas Instruments MSP430FG4618/F2013 Experimenter Board MSP-EXP430FG4618 MSP-EXP430FG4618 Data Sheet
Product codes
MSP-EXP430FG4618
12
MSP430F2013 Programming
1.
Connect the 14-pin cable to JTAG2 header on the board.
2.
Create a new project or load a valid existing project on the IAR Embedded
Workbench.
3.
In IAR Embedded Workbench under the Project drop-down choose Options;
this brings up the menu shown in Figure A-1. Under the General
Options
Options
ÆTarget
choose MSP430F2013 from the MSP430x2xx Family
option.
4.
From the same menu under the Debugger option select the FET Debugger
shown as a snapshot in Figure A-2.
5.
Then proceed to the FET Debugger option and choose the Texas Instrument
USB-IF as shown in Figure A-3. The default setting of Automatic needs no
change.
6.
For a new project created, the Spy-Bi-Wire interface is the default setting for
the MSP430F2013. If this selection needs modification, under the FET
Debugger
Debugger
menu as shown in Figure A-4, check the Override default box and
then make the Spy-Bi-Wire selection instead of the 4-Wire JTAG. It is to be
noted that the Parallel FET does not support the Spy-Bi-Wire interface and
cannot be used to debug/program the MSP430F2013.
Figure A-4: Selection of the Spy-Bi-Wire interface for MSP430F2013