Texas Instruments MSP430FG4618/F2013 Experimenter Board MSP-EXP430FG4618 MSP-EXP430FG4618 데이터 시트

제품 코드

MSP-EXP430FG4618

MSP430F2013 Programming

Connect the 14-pin cable to JTAG2 header on the board.

Create a new project or load a valid existing project on the IAR Embedded

Workbench.

In IAR Embedded Workbench under the Project drop-down choose Options;

this brings up the menu shown in Figure A-1. Under the General
Options

ÆTarget

choose MSP430F2013 from the MSP430x2xx Family

option.

From the same menu under the Debugger option select the FET Debugger

shown as a snapshot in Figure A-2.

Then proceed to the FET Debugger option and choose the Texas Instrument

USB-IF as shown in Figure A-3. The default setting of Automatic needs no

change.

For a new project created, the Spy-Bi-Wire interface is the default setting for

the MSP430F2013. If this selection needs modification, under the FET
Debugger

menu as shown in Figure A-4, check the Override default box and

then make the Spy-Bi-Wire selection instead of the 4-Wire JTAG. It is to be

noted that the Parallel FET does not support the Spy-Bi-Wire interface and

cannot be used to debug/program the MSP430F2013.

Figure A-4: Selection of the Spy-Bi-Wire interface for MSP430F2013