Microchip Technology Microstick for the 5V PIC24F K-series DM240013-2 DM240013-2 Data Sheet

 2013 Microchip Technology Inc.

DS30003030B-page 3

• High-Current Sink/Source, 18 mA/18 mA All Ports
• Independent Ultra Low-Power, 32 kHz 

Timer Oscillator

• Up to Two Master Synchronous Serial Ports 

(MSSPs) with SPI and I

2

C™ modes:

In SPI mode:
- User-configurable SCKx and SDOx pin outputs 
- Daisy-chaining of SPI slave devices
In I

2

   

   C mode:

- Serial clock synchronization (clock stretching)
- Bus collision detection and will arbitrate 

accordingly

- Support for 16-bit read/write interface

• Up to Two Enhanced Addressable UARTs:

- LIN/J2602 bus support (auto-wake-up, 

Auto-Baud Detect, Break character support)

- High and low speed (SCI)
- IrDA

®

 mode (hardware encoder/decoder 

function)

• Two External Interrupt Pins
• Hardware Real-Time Clock and Calendar (RTCC)
• Configurable Reference Clock Output (REFO)
• Two Configurable Logic Cells (CLC)
• Up to Two Single Output Capture/Compare/PWM 

(SCCP) modules and up to Three Multiple Output 
Capture/Compare/PWM (MCCP) modules

• Wide Operating Voltage Range Options:

- 1.8V to 3.6V (PIC24F devices)
- 2.0V to 5.0V (PIC24FV devices)

• Selectable Power Management modes:

- Idle: CPU shuts down, allowing for significant 

power reduction 

- Sleep: CPU and peripherals shut down for 

substantial power reduction and fast wake-up

- Retention Sleep mode: PIC24FV devices can 

enter Sleep mode, employing the 
Retention Regulator, further reducing power 
consumption

- Doze: CPU can run at a lower frequency than 

peripherals, a user-programmable feature

- Alternate Clock modes allow on-the-fly 

switching to a lower clock speed for selective 
power reduction

• Fail-Safe Clock Monitor:

- Detects clock failure and switches to on-chip, 

low-power RC Oscillator

• Ultra Low-Power Wake-up Pin Provides an 

External Trigger for Wake from Sleep

• 10,000 Erase/Write Cycle Endurance Flash 

Program Memory, Typical

• 100,000 Erase/Write Cycle Endurance 

Data EEPROM, Typical

• Flash and Data EEPROM Data Retention: 20 Years 

Minimum

• Self-Programmable under Software Control
• Power-on Reset (POR), Power-up Timer (PWRT) 

and Oscillator Start-up Timer (OST)

• Watchdog Timer (WDT) with its Own On-Chip 

RC Oscillator for Reliable Operation

• On-Chip Regulator for 5V Operation
• Selectable Windowed WDT Feature
• Selectable Oscillator Options including:

- 4x Phase Locked Loop (PLL)

• 8 MHz (FRC) Internal RC Oscillator:

- HS/EC, High-Speed Crystal/Resonator 

Oscillator or External Clock

• In-Circuit Serial Programming™ (ICSP™) and 

In-Circuit Emulation (ICE) – via Two Pins

• In-Circuit Debugging
• Programmable High/Low-Voltage 

Detect (HLVD) module

• Programmable Brown-out Reset (BOR):

- Software enable feature
- Configurable shutdown in Sleep
- Auto-configures power mode and sensitivity 

based on device operating speed

- LPBOR available for re-arming of the POR