Microchip Technology MA330017 Data Sheet
© 2007-2012 Microchip Technology Inc.
DS70283K-page 65
dsPIC33FJ32MC202/204 and dsPIC33FJ16MC304
6.3
System Reset
The dsPIC33FJ32MC202/204 and dsPIC33FJ16MC304
family of devices have two types of Reset:
• Cold Reset
• Warm Reset
A cold Reset is the result of a Power-on Reset (POR)
or a Brown-out Reset (BOR). On a cold Reset, the
FNOSC configuration bits in the FOSC device
configuration register selects the device clock source.
family of devices have two types of Reset:
• Cold Reset
• Warm Reset
A cold Reset is the result of a Power-on Reset (POR)
or a Brown-out Reset (BOR). On a cold Reset, the
FNOSC configuration bits in the FOSC device
configuration register selects the device clock source.
A warm Reset is the result of all other reset sources,
including the RESET instruction. On warm Reset, the
device will continue to operate from the current clock
source as indicated by the Current Oscillator Selection
bits (COSC<2:0>) in the Oscillator Control register
(OSCCON<14:12>).
The device is kept in a Reset state until the system
power supplies have stabilized at appropriate levels
and the oscillator clock is ready. The sequence in
which this occurs is shown in
including the RESET instruction. On warm Reset, the
device will continue to operate from the current clock
source as indicated by the Current Oscillator Selection
bits (COSC<2:0>) in the Oscillator Control register
(OSCCON<14:12>).
The device is kept in a Reset state until the system
power supplies have stabilized at appropriate levels
and the oscillator clock is ready. The sequence in
which this occurs is shown in
TABLE 6-1:
OSCILLATOR PARAMETERS
Oscillator Mode
Oscillator
Start-up Delay
Oscillator Start-up
Timer
PLL Lock Time
Total Delay
FRC, FRCDIV16,
FRCDIVN
FRCDIVN
T
OSCD
—
—
T
OSCD
FRCPLL
T
OSCD
—
T
LOCK
T
OSCD
+ T
LOCK
XT
T
OSCD
T
OST
—
T
OSCD
+ T
OST
HS
T
OSCD
T
OST
—
T
OSCD
+ T
OST
EC
—
—
—
—
XTPLL
T
OSCD
T
OST
T
LOCK
T
OSCD
+ T
OST
+ T
LOCK
HSPLL
T
OSCD
T
OST
T
LOCK
T
OSCD
+ T
OST
+ T
LOCK
ECPLL
—
—
T
LOCK
T
LOCK
SOSC
T
OSCD
T
OST
—
T
OSCD
+ T
OST
LPRC
T
OSCD
—
—
T
OSCD
Note 1: T
OSCD
= Oscillator Start-up Delay (1.1
μs max for FRC, 70 μs max for LPRC). Crystal Oscillator start-up
times vary with crystal characteristics, load capacitance, etc.
2: T
OST
= Oscillator Start-up Timer Delay (1024 oscillator clock period). For example, T
OST
= 102.4
μs for a
10 MHz crystal and T
OST
= 32 ms for a 32 kHz crystal.
3: T
LOCK
= PLL lock time (1.5 ms nominal), if PLL is enabled.