Voltcraft CPPS-160-42, 1 Output Variable DC Power Supply, , Bench CPPS-160-42 User Manual

Product codes

CPPS-160-42

It could be that the voltage setting requires approx. 1-2 seconds to adjust

from a high to a low voltage value through the large control range.

The device works in constant voltage mode during normal operation. This means

that the power supply delivers a constant preset output voltage. This mode is

signaled with the green C.V. status display (2).

c) Connecting a consumer

When connecting a consumer to the power supply please ensure that it is

switched off. The maximum power consumption of the connected consumer

should not exceed the specifications in the technical data.
Dangerous contact voltages (> 75 VDC) can be generated with the series

connection of outputs of several power supplies, which could be a risk

to life when touching. Only insulated accessories (connection cables,

measuring lines etc.) may be used from this voltage . The use of metallic

cables and contacts should be avoided. All these blank points should be

covered with suitable, flame resistant insulating material or other measures

and protected from direct contact and short circuits.
Please ensure a sufficient conductor cross section for the intended current

strength .

1. Remove the connected consumer from the output.

2. Switch on the power supply via On / off switch POWER (1) The display (2) lights up and the

voltage and current indicator appears in the display.

3. Set the parameters according to your guidelines as described in the chapter "Start up".

Check the correctly set output voltage once more.

4. Connect the positive pole (+) of the consumer to the red socket "+" and the negative pole (-)

to the black socket "-" of the output.

The load can be connected via the green sockets where required.

1182100-1182103_v1_1114_02_m_(3).indb 48

5/11/14 18:24