Thecus N3200 Leaflet
LAN Configuration
The N3200 supports two Gigabit Ethernet
ports for higher service availability. To
ports for higher service availability. To
configure these ports, choose LAN from the
Network menu, and the LAN
Network menu, and the LAN
Configuration screen appears. Press Apply
to save your changes.
to save your changes.
LAN Configuration
Item Description
MAC Address
MAC Address
Displays the MAC address of the LAN interface.
Jumbo Frame Support
Enable or disable Jumbo Frame Support on the LAN interface.
IP
Specifies the IP address of the LAN interface.
Netmask
Specifies the Network Mask of the LAN interface.
NOTE
Before enabling Jumbo Frame Support, please make sure your network equipment
supports Jumbo Frame. If your equipment is incompatible, you might not be able to
connect to your N5200PRO. In this case, you have to reset the system back to
connect to your N5200PRO. In this case, you have to reset the system back to
default by the holding down front panel reset button for 5 seconds during boot up
process.
process.
DHCP Configuration
A DHCP server can be configured to assign IP addresses to devices connected to
the LAN port. To configure these ports, choose LAN from the Network menu.
the LAN port. To configure these ports, choose LAN from the Network menu.
DHCP Configuration
Item Description
DHCP Server
DHCP Server
Enable or disable the DHCP server to automatically assign IP
address to PCs connected to the LAN interface.
Start IP
Specifies the starting IP address of the DHCP range.
End IP
Specifies the ending IP address of the DHCP range.
DNS Server
Specifies the DNS server IP address.
The IP Segment of WAN and LAN should not overlap.
NOTE
The IP address of the LAN interface should not be in the range of the Start IP
address and End IP address.
WARNING
34