Reely remote control RtF 2100 mm 1289571 Data Sheet

The wings are installed in the fuselage slots on the left and right. 
For this, push the two enclosed wing connectors (2) into one wing (1). The thin wing connector is pushed into the rear 

hole. The thicker wing connector goes in the front hole. 
The front wing connector is later secured with one screw each with the wing pushed on. To install the wing connector, 

these screws may need to be turned out a little at initial assembly (see figure 6).
Push the wing connectors (2) into the hole of the middle fuselage part. 
Push the plug of the aileron servo against the counterpiece (3) of the wing holder. The servo plugs match the counter-

piece only in one position. To make plugging in easier, the counterpieces can also be pulled from the plastic holder.
Carefully push the wing half into the cut-out at the fuselage until the shaping of the wing is flush with the fuselage.

Observe that the servo cable is not caught and pushed into the fuselage. 
Then install the second wing half on the fuselage in the same manner.