ParkZone T-28 Trojan PNP PKZ4475 Data Sheet

CAUTION: DO NOT handle the motor or ESC while the fl ight battery is 

connected to the ESC. Personal injury could result.

1.  Use a tool to remove the spinner nut (A) from the collet (B).
2.  Remove the propeller (C), backplate (D) and collet from the motor shaft.
3.  Remove three screws (E) from the cowling (F).
4.  Carefully remove the cowling from the fuselage. Paint may keep the 

cowling attached to the fuselage.

5.  Remove four screws (G) from the motor mount (H) and fuselage.
6.  Disconnect the motor wires from the ESC wires.
7.  Remove four screws (I) and motor (J) from the motor mount. Keep 

the rubber washers attached to the motor mount when removing the 
screws and motor from the motor mount.

1.  Assemble in reverse order. Correctly align the colors of the motor wires 

with the wire colors of the ESC.

NOTICE: Make sure the propeller side with the numbers for diameter and 
pitch (9.5 x 7.5) faces out from the backplate. A tool is required to tighten 
the spinner nut on the collet.

Not all wiring shown. 

High Rate

Low Rate

Aileron

13mm up/down

9.5mm up/down

Elevator

16mm up/down

13mm up/down

Rudder

22mm left/right

16mm left/right

We recommend using a DSM2/DSMX aircraft transmitter capable of dual rates. 
Adjust according to individual preferences after initial fl ight.

1.5X10mm (4)

2X5mm (3)

3X10mm (4)

CAUTION: Always disconnect the fl ight battery from the model before removing the propeller.