ParkZone T-28 Trojan PNP PKZ4475 Data Sheet

1.  Remove the canopy from the fuselage. 
2.  Turn the wing and fuselage so their bottom sides 

face up. 

3.  Place the wing’s aileron servo connectors (A) into the 

rectangular hole in the fuselage. 

4.  Slide the two guide pins (B) of the wing into the two 

holes in the fuselage.

5.  Align and attach the wing to the fuselage using 

a screw (C).

6.  Inside the fuselage, connect both aileron servo 

connectors to the aileron Y-harness.  There is no 
difference between the two connections on a Y-
harness. Left and right servo connectors do not have 
to be connected to a particular side of a Y-harness.

7.  When needed, disassemble in reverse order.

CAUTION: DO NOT crush or otherwise damage 

wiring when attaching the wing to the fuselage.

NOTICE: Use of CA (cyanocrylate adhesive) accelerant on 
your model can damage paint. DO NOT handle the model 
until the accelerant fully dries.

•  Lower throttle and 

throttle trim to 
lowest settings.

•  Connect battery 

to ESC.

Continuous LED

Series of tones

Power on 

Transmitter

Wait 5 

seconds

3 X 25mm

1.   Remove the wing to install a receiver.
2.   Install your parkfl yer or full-range receiver in the fuselage using hook and 

loop tape or double-sided servo tape.

3.  Attach the elevator and rudder servo connectors to the appropriate chan-

nels of the receiver.

4.   Attach the aileron Y-harness to the aileron channel of the receiver. 
5.   Attach the ESC connector to the throttle channel of the receiver.

1.   The required battery is a 1800–2200mAh 11.1V Li-Po battery. We recom-

mend the ParkZone

®

 1800mAh (PKZ1031) or the 2200mAh (PKZ1029).

2.  If using another battery, the battery must be at least a 1800–2200 mAh 

battery.

3.   Your battery should be approximately the same capacity, dimensions and 

weight as the ParkZone Li-Po battery to fi t in the fuselage without changing 
the center of gravity.