Thunder Tiger Brushless 1:8 RC model car Electric 6403-F113 User Manual

1mm

2mm

3mm

5mm

10mm

Hard Suspension
懸吊較硬

Soft Suspension
懸吊較軟

Stop (Neutral)

停（中立點）

Reverse

後退

Brake

煞車

Acceleration

加速

Stop (Neutral)

停（中立點）

Reverse

後退

Brake

煞車

Acceleration

加速

a. The truck ride height can be increased by adding preload clips to the shocks. 

Removing preload clips will decrease the ride height.

b. Compress the spring and insert the preload clips between the spring collar and the 

shock body flange.

a. 車身高度可利用避震器調整墊片改變。增加調整墊片可增加車高；反之則降低車高。
b. 安裝或拆卸墊片時，請壓縮避震器彈簧再置入或取出墊片即可。

a. Use a 1.5mm Allen wrench as shown to adjust the front & rear toe-in.
b. Lengthening the Turnbuckles will increase the amount of toe-in, shortening them will 

increase the amount of toe-out.

c. The notch on the turnbuckle indicates the side that has the right-hand thread. Use it 

as a guide to determine which way to turn the turnbuckle when adjusting its length.

a. 使用1.5mm六角扳手調整前、後輪束角。
b. 增長螺距將會增加內束角角度；縮短螺距將會增加外束角角度。

請參照本說明調整您愛車前、後輪的傾角。

a. Use a 2.5mm Allen wrench as shown to adjust the front & rear camber.
b. Turning the upper pivot ball clockwise increases camber towards the negative 

side; turning it counter-clockwise increases camber towards the positive side.

a. 使用2.5mm六角扳手調整前、後輪傾斜角（如圖示）。
b. 調整上輪軸球頭順時針旋轉將增加負傾斜角；反之，將增加正傾斜角。

請參照本說明調整您愛車前、後輪的傾角。

a. Always turn off the radio system and disconnect the battery pack when the car is not in use.
b. Remove sand, mud, dirt, and any other elements before storing the car.
c. Never use chemicals or any solvents to clean the chassis as it may cause damage to the electronics components and plastic parts. 

Use compressed air, soft paintbrush, or toothbrush to clean dust and dirt.

a. 結束操控儲存車體前，請謹記要關閉電源，並將電池接頭拔除，以免電池短路造成不必要之危險。
b. 清潔車體上所沾附之沙塵、泥屑。
c. 請勿使用化學清潔劑來清洗底板，以免遙控之電子設備受潮、電線、焊點及膠件被侵蝕而導致不必要之損壞。清潔車體時，請儘量

使用強力之壓縮空氣，搭配軟毛刷來請清理車體上所沾附之沙塵、泥屑。

正傾角

Camber
負傾角