Uhlenbrock 65100 Intellibox II DCC System 65100 Data Sheet
Product codes
65100
Intellibox II
15
Figure 2.61 Connection of the flat cable
Figure 2.71 Connection of flat cables
The plugs must be connected to the so that the cable on
the Intellibox and the Booster 6017 go to the top and on
the Booster 6015 to the bottom (as shown in the
diagram).
the Intellibox and the Booster 6017 go to the top and on
the Booster 6015 to the bottom (as shown in the
diagram).
Note: If the Booster Power 4 (Part No. 63 240) is to
transmit the Selectrix Format it must be connected to the
Intellibox Märklin Booster socket.
transmit the Selectrix Format it must be connected to the
Intellibox Märklin Booster socket.
Tip: The Märklin Booster outputs the DCC Format when Special option 901 is set to “3“
(Setting see Chapter 4.10), otherwise the Intellibox will report the error „Short Circuit“ as
soon as the Märklin Booster is connected and the DCC Format is output.
(Setting see Chapter 4.10), otherwise the Intellibox will report the error „Short Circuit“ as
soon as the Märklin Booster is connected and the DCC Format is output.
2.7 Connecting s88 Modules
Feedback modules serve to monitor track sections and trains in automatic operations on a
model railway layout.
All feedback modules that conform to the Märklin s88 standard can be used on the s88
feedback input.
model railway layout.
All feedback modules that conform to the Märklin s88 standard can be used on the s88
feedback input.
The flat cable supplied with the module is used to
connect the module to the Intellibox s88 input socket.
connect the module to the Intellibox s88 input socket.
On both devices the plug must be connected so that
the flat cable goes downwards.
the flat cable goes downwards.
If
more modules are used the flat cable is connected from output of the last module to the
input of the next module so that all modules are daisy chained and connected to the s88
feedback bus (see also the manual of the particular module).
feedback bus (see also the manual of the particular module).
2.8 Connecting IRIS Receivers
Receiver
The built-in receiver is located under the front panel
to the right of the [C]-key. During operation the
remote control IRIS (Part No. 66510) should always
be held in the direction of the receiver (see
illustration).
In difficult situations such as a model railway layout in
two rooms, two further external receivers can be
used.
The built-in receiver is located under the front panel
to the right of the [C]-key. During operation the
remote control IRIS (Part No. 66510) should always
be held in the direction of the receiver (see
illustration).
In difficult situations such as a model railway layout in
two rooms, two further external receivers can be
used.
Auxiliary Receiver
Auxiliary receivers (Part No. 66520) are connected to
the 5-pole DIN-socket, designated “IRIS receiver“. A
single auxiliary receiver can be connected directly.
When two auxiliary receivers are used they are
connected to the Intellibox via a Y-cable.
Auxiliary receivers (Part No. 66520) are connected to
the 5-pole DIN-socket, designated “IRIS receiver“. A
single auxiliary receiver can be connected directly.
When two auxiliary receivers are used they are
connected to the Intellibox via a Y-cable.