Renkforce 3D printer assembly kit RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
11
Assembly of the drive motor
1x actuator
1x bottom plate
4x cylinder head screw M3x12
Attach the actuator to the bottom plate with the 4 screws as
shown in the figure.
Apply screws with threadlocker varnish.
The cable exit of the actuator must point at the long side of the
plate as shown.
Inserting the grooved ball bearings
2x grooved ball bearings
1x bottom plate
Insert the grooved ball bearings into the corresponding bores
of the bottom plate from above.
Turn the grooved ball bearings slightly, when inserting them
into the bores. Do not apply any force. The flanges of the
grooved ball bearings must be cleanly aligned with the top of
the bottom plate.