Renkforce 3D printer assembly kit RF1000 Single extruder (value.974113) RF1000 Data Sheet
Product codes
RF1000
9
Application of the threadlocker varnish
In the following instruction, some screws must be secured with threadlocker varnish. This is indicated accordingly in the text.
Procedure:
Put a small drop of threadlocker varnish medium-strength onto the thread start. Observe that you must only use a small drop as
In the following instruction, some screws must be secured with threadlocker varnish. This is indicated accordingly in the text.
Procedure:
Put a small drop of threadlocker varnish medium-strength onto the thread start. Observe that you must only use a small drop as
shown in the following screen.
b) Assembly of the Components
Attachment of the motor pinion to the actuators
3x actuator
3x sprocket 14Z (small pinion, outer dia. 16 mm)
6x threaded pin M3 x 5
Push sprockets onto axes of the actuators and attach them
with 2 threaded pins each. Apply threaded pins with thread-
locker varnish.
The motor axes must end flush with the upper edges of the
sprockets.