Phoenix Contact 2701027 NLC-050-024D-06I-04QTP-00A nanoLine Base Unit 24ßV/DC / PNP 2701027 Data Sheet

Product codes

2701027

General Programming Techniques

2373_en_B

PHOENIX CONTACT

3-21

3.7

Connecting Flow Chart Blocks

To draw flow chart block connecting lines, follow these steps:

Move the cursor to the bottom (or side for Decision and Compare blocks) connecting

point of a block that doesn’t have an outgoing flow line. The connecting point turns

orange (or the specified color) to indicate a potential outgoing connector pointer, and

the cursor changes to the connector pointer.

Click the outgoing connector point.

Move the cursor to the next block’s top (incoming) connector point, which will turn green

(or the specified color).

Click the incoming connector to complete the line. The cursor changes back to the

selector pointer.

If the flow chart editor is inadvertently in connect mode, press the <Esc> key to switch

back to select mode.

nanoNavigator supports automatic routing from one block to another, so it is only

necessary to click the outgoing connector of one block and the incoming connector of the

next to generate the flow line. It is always possible to manually draw the flow line by

clicking from point-to-point to route the line.