Hirschmann DVB-T antenna HIRSCH Data Sheet

6

– Voltage supply: The supply voltage is

electrically isolated from the housing.

– Ground connection: The SPIDER is 

grounded via a pin of the 3pin terminal
block.

Fig. 3: Pin configuration of 3pin terminal

block

2.1 CONNECTING DTE AND OTHER
NETWORK SEGMENTS
It is possible to connect with
– SPIDER 3TX-TAP up to three
– SPIDER 5TX, SPIDER 5TX EEC up to five
– SPIDER 8TX, SPIDER 8TX EEC up to eight
– SPIDER 1TX/1FX... up to one
– SPIDER 4TX/1FX... up to four
data terminal equipments (DTE) or other
network segments to the 10/100 Mbit/s
ports using twisted pair cabling (ref. Fig. 4).

One further data terminal equipment or
optical network component can be connec-
ted at 100 Mbit/s to the optical port of the 
– SPIDER 1TX/1FX...
– SPIDER 4TX/1FX...
using fiber optic cable. 

䡺 Check whether the package was deliver-
ed complete (see scope of delivery).

䡺 Check the individual parts for transport
damage.

z

Warning!
Use only undamaged parts!

3.2 ASSEMBLY
The equipment is delivered in a ready-to-
operate condition. The following procedure
is appropriate for assembly:

+24 V

0 V

䡺 Pull the terminal block off the SPIDER
and wire up the supply voltage lines.

䡺 Fit the SPIDER on a 35 mm standard bar
to DIN EN 50 022.

䡺 Attach the upper snap-on slide bar of
the SPIDER to the standard bar and press it
down until it locks in position.

䡺 Fit the signal lines.
Notes:
– The SPIDER is grounded via a pin of the

terminal block.

– Do not open the housing.

– The shielding ground of the twisted pair

lines which can be connected is electrical-
ly connected to the ground connection.

Fig. 5: Assembling the SPIDER

Fig. 6: Dimensions 

13,7

70

63,3

23

8,5

䡺 You start up the SPIDER by connecting
the supply voltage via the 3-pin terminal
block.

䡺 To take the SPIDER off the ISO/DIN rail,
unlock the snap-in mechanism according to
Fig 7.

Fig. 7: Dismantling the SPIDER

In the event of technical queries, please talk
to the Hirschmann contract partner respon-
sible for looking after your account or
directly to the Hirschmann office. You can
find the addresses of our contract partners
– on the Internet 

http://www.hirschmann-ac.com

Our support line is also at your disposal:
Tel. +49(1805) 14-1538
Fax +49(7127) 14-1551

Answers to Frequently Asked Questions can
be found on the Hirschmann product site 

http://www.hirschmann-ac.com
The FAQs are located under „Service“ in
the Automation and Network Solutions
section.
www.hicomcenter.com gives you an up-to-
date overview of training courses about
technology and products.

MICE

SPIDER

Fig. 4: Configuration with SPIDER: Connection of (depending on product type):

– up to 8 data terminal equipments or further segments via TP
– and up to 1 data terminal equipment or further segment via F/O