Buffalo TeraStation 5200 TS5200D0202-EU Data Sheet

177

Recovery I41
PushFuncToStart

Pressing the function button on the 

front will start the recovery process.

-

Recovery I42
Preparing

Preparing to start the recovery 

process.

-

Recovery I43
Unsupported HW

The TeraStation was started from the 

USB recovery device, but the system 

cannot be recovered from this USB 

recovery device.

-

Recovery I44
Disk1 not found

Recovery from the USB recovery 

device was initiated, but the drive 1 

was not detected.

Make sure that Disk 1 is present and fully inserted in 

its slot.

Recovery I45
Recovery Failed

Recovery failed.

-

RAID ARRAY I46
RMM+Processing

Data migration or conversion (RAID 

migration) is in progress.

Do not turn off the TeraStation power.

SYSTEM I47
Don’t Power Off

FailOver I48
PushFuncToStart

This TeraStation is ready to become 

the failover backup for the main 

TeraStation.

Hold down the function button on the front of the 

target TeraStation until it stops beeping to accept 

failover backup status.

FailOver I49
LostMainTarget

The main TeraStation in the failover 

configuration cannot be found.

Make sure that the main TeraStation is on, working, 

and connected to the network.

FailOver I50
Maintenance mode

Failover maintenance is in progress.

Do not turn off the TeraStation power.

FailOver I51
Initializing

Initializing the failover configuration.

Do not turn off the TeraStation power.

New Firmware I52
Available

A new firmware version has been 

released.

Update the firmware.

BackupTask xx I54
Backup Failure

xxth backup task failed.

Make sure that the xxth backup task is configured 

correctly. Make sure that the NAS is not in standby 

mode. If the backup task still fails, check the 

network, backup source, and backup destination.

Recovery I55
RecoveryAuthFail

Authentication during recovery of 

settings failed.

Settings can only be restored for the TeraStation 

whose settings were originally saved. To restore 

settings, insert the USB memory device, move the 

Boot Mode switch on the rear of the TeraStation 

to the USB position, and restart the TeraStation. 

Or, settings can be restored in Settings with the 

TeraStation powered on.

Surveillance I56
Lack of License

There are not enough surveillance 

camera server licenses.

Purchase and register an additional license.

Surveillance I57
No free space

There is not enough space to  save 

additional surveillance video.

Delete or move some of the stored video.

Surveillance I58
Recording Failure

Video not recorded.

Check your settings. Also, use the utilities provided 

with your camera to check that the camera is 

operating correctly.