Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

  Move the cursor to the [ACT] item and touch 

the RTN button to switch to the data input 

mode. Select the ACT mode by scrolling the 

touch sensor. 

*The display blinks.

  Touch the RTN button to activate the 

function and return to the cursor mode. (ON 

is displayed.)

  When setting a switch, move the cursor to 

the [SW] item and touch the RTN button to 

call the selection screen. Select the switch 

and set its ON direction. (Always ON at "--" 

setting)

*For a description of the switch selection method, see the 

description at the back of this manual.

  Move the cursor to the aileron, flap or 

elevator rate item and touch the RTN button 

to switch to the data input mode. Adjust the 

rate independently by scrolling the touch 

sensor. 

  Initial value: 0%
  Adjustment  range:  -200~+200%  (Elevator:  

-120~+120%)

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to end the adjustment 

and return to the cursor mode.

Output (Y)

Position (X)

Offset point

Fixed (0)

Fixed (offset 

position)

2- Intermediate point

Settable

Settable

1- End point

Settable

Fixed

* The range where mixing does not work close to the neutral 

position of the elevator stick can be adjusted. (Glider only)

*When offset is set, the curve is initialized.

  Move the cursor to the [OFFSET] item and 

hold the airbrake stick to the desired position 

and then touch the RTN button for one 

second to set the butterfly operational 

reference point. 

  Initial value: 0% (upper side)
  Adjustment range: 0~100% 

  Move the cursor to the aileron, flap or 

elevator speed item and touch the RTN 

button to switch to the data input mode. 

  Adjust the rate by scrolling the touch sensor. 
  Initial value: 0
  Adjustment range: 0~27 (maximum delay)

*When the RTN button is touched for one second, the rate is 

reset to the initial value.)

  Touch the RTN button to activate the 

function and return to the cursor mode.

AIL 3

(Chip Aileron)

AIL 4

(Chip Aileron)

AIL1

(Main Aileron)

AIL 2

(Main Aileron)

FLP 2

(Camber Flap)

FLP 1

(Camber Flap)

ELEVATOR

ELEVATOR 2

V-TAIL

ELEVATOR ELEVATOR 2

AILVATOR

FLP  3

(Brake Flap)

FLP  4

(Brake Flap)