Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

Product codes
1-F8075
Page of 168
134
<Model Menu (Airplane/Glider Functions)>
Setting method
●Activate the function
  Move the cursor to the [ACT] item and touch 
the RTN button to switch to the data input 
mode. Select the ACT mode by scrolling the 
touch sensor. 
*The display blinks.
  Touch the RTN button to activate the 
function and return to the cursor mode. (ON 
is displayed.)
  When setting a switch, move the cursor to 
the switch item and touch the RTN button 
to access the selection screen. Select the 
switch and set its ON direction. (Always ON 
at "--" setting)
*For a description of the switch selection method, see the 
description at the back of this manual.
●Trim offset rate adjustment
  Move the cursor to the aileron, flap or 
elevator rate item and touch the RTN button 
to switch to the data input mode. Adjust the 
rate independently by scrolling the touch 
sensor. 
  Initial value: 0%
  Adjustment range: -250~+250%
*When the RTN button is touched for one second, the rate is 
reset to the initial value.)
  Touch the RTN button to end the adjustment 
and return to the cursor mode.
●Condition delay setting
  Move the cursor to the [COND.DELAY] item 
and touch the RTN button to switch to the 
data input mode. Adjust the condition delay 
by scrolling the touch sensor. 
  Initial value: 0
  Adjustment range: 0~27
*When the RTN button is touched for one second, the servo 
operation position is reset to the initial value.)
  Touch the RTN button to end the adjustment 
and return to the cursor mode.
  When setting a cut switch, move the cursor 
to  the  [CUT-SW]  item  and  touch  the  RTN 
button to access the selection screen. Select 
the switch and set its ON direction. (Always 
ON at "--" setting)
*For a description of the switch selection method, see the 
description at the back of this manual. 
●Servo speed setting
  Move the cursor to the aileron, flap or 
elevator speed item and touch the RTN 
button to switch to the data input mode. 
  Adjust the rate by scrolling the touch sensor. 
  Initial value: 0
  Adjustment range: 0~27 (maximum delay)
*When the RTN button is touched for one second, the rate is 
reset to the initial value.)
  Touch the RTN button to activate the 
function and return to the cursor mode.
●Auto switch selection
  When selecting an auto switch, move the 
cursor to the [AUTO-SW] item and touch the 
RTN button to access the selection screen. 
Select the switch and set its ON direction. 
(Always ON at "--" setting)
*For a description of the switch selection method, see the 
description at the back of this manual.
AIL 3
(Chip Aileron)
AIL 4
(Chip Aileron)
AIL1
(Main Aileron)
AIL 2
(Main Aileron)
FLP 2
(Camber Flap)
FLP 1
(Camber Flap)
ELEVATOR
ELEVATOR 2
V-TAIL
ELEVATOR ELEVATOR 2
AILVATOR
FLP  3
(Brake Flap)
FLP  4
(Brake Flap)