Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

*When [rpm] mode is selected above setting, the display 

mode can be selected.

* There is no change in the transmitter output even when the 

"MODE" is changed. Calibration should be performed via 

the governor.

* In order to use the Governor function of the T14SG, it is 

necessary to change the settings on the governor for the low 

side 700 rpm mode.

　

When the MODE of the Governor screen's

model menu is changed, the change is also

indicated on-screen.

The chart below indicates the mode percentage and 

the corresponding RPM.

MODE

0％

50％

100％ 110％

1000-2000rpm 1000rpm 1500rpm 2000rpm 2100rpm
1000-2500rpm 1000rpm 1500rpm 2500rpm 2700rpm
1000-3500rpm 1000rpm 1500rpm 3500rpm 3900rpm

700-2000rpm 700rpm 1500rpm 2000rpm 2100rpm
700-2500rpm 700rpm 1500rpm 2500rpm 2700rpm
700-3500rpm 700rpm 1500rpm 3500rpm 3900rpm

 

 Move the cursor to the [--] item and touch

the  RTN  button  to  access  the  selection

screen. Select the control.

*For a description of the switch selection method, see the 

description at the back of this manual.

 Move the cursor to the rate item and touch

the RTN button to switch to the data input

mode.

 Adjust the trim rate by scrolling the touch

sensor.

 Initial value: 0% (0rpm)
 Adjustment range: -20~+20% (-200~+200rpm)

*When  the  RTN  button  is  touched  for  one  second,  the 

sensitivity is reset to the initial value.)

 Touch the RTN button to return to the cursor

mode.

Generally,  RPM  rate  is  interlocked  with

condition and changes a rate.

How  to  change  two  rates  in  the  same

condition here.

1. Select [GOVERNOR] at the Model menu

and access the setup screen shown below

by touching the RTN button.

2.  Move  the  cursor  to  the  [COND]  item

and touch the RTN button to access the

selection screen. Select the [SW]. Touch the

RTN button to return to the cursor mode.

And [INH] is set to [ACT].

3. # number shows the present switch state. In

the state of # 1 a cursor is moved to [--] and

RTN is pushed.

4. [SF] is chosen by [H/W SELECT] and then a

top is turned ON.

5. [MODE] and [RATE] of a state of "#1=SF

top"are set up.

6.  It  is  a  setup  of  "#2".  Move  the  cursor  to

the [#1] item and touch the RTN button

to access the selection screen. Select the

[#2]. Touch the RTN button to return to the

cursormode. And [INH] is set to [ACT].

●

The number

of a SW state