Futaba Hendheld RC 2.4 GHz No. of channels: 14 1-F8075 Data Sheet

● Select the function name

and return to the Model

menu  by  touching  the 

R T N   b u t t o n . 　 O r   t h e 

H O M E / E X I T   b u t t o n   i s

pushed.

When using a Futaba GV-1/GY701/CGY750 

governor, this function is used to switch the RPM 

of the helicopter's rotor head. The rotor head speed 

can be switched with each condition or the switch.

*The governor is used by connecting the governor speed 

setting channel to CH7 (initial setting).

*When using an independent governor [ON]/[OFF] switch, 

connect the AUX([ON]/[OFF]) connector of the governor to 

CH8 and set the switch to CH8 (Governor2) at the Function 

menu of the Linkage Menu.

● Select [GOVERNOR] at the Model menu and

access  the  setup  screen  shown  below  by

touching the RTN button.

Scrolling

● Moving cursor

● Selecting mode

● Adjusting value

● To next page

(Currently selected condition name)

●Unit display selection:
 [%]/[rpm]

●Setup screen selection

●ACT/INH: INH (initial setting)

●Fine tuning VR settings

●RPM adjustment

●Condition/Switch selection

 When using this function, move the cursor to

the [INH] item and touch the RTN button to

switch to the data input mode.

 Select the ACT mode by scrolling the touch

sensor.

*The display blinks.

 Touch the RTN button to activate the mixing

and  return  to  the  cursor  mode.  (ON  is

displayed.)

　

When  the  Governor  is  changed  from  the

default inhibited (INH) state to the active

(ACT)  state,  the  endpoint  menu  will  be

displayed  and  it  is  possible  to  utilize  the

endpoints for this given condition.

*When the function is set ON/OFF at the governor setup 

screen, the governor rpm setting channel end point servo 

travel and limit point are now initialized.

*When changed from INH to ACT (ON), the servo travel is 

initialized to 100 and the limit point is initialized to 155.

*When operation is changed to INH at all conditions, the 

servo travel is initialized to 100 and the limit point is 

initialized to 135.

　

Use the SensorTouch to scroll to either YES

(incorporate the default endpoints) or NO

(endpoints are not utilized. Press the Return

(RTN) button to confirm the selection made.

 Move the cursor to the rate item and touch

the RTN button to switch to the data input

mode.

 Adjust the rpm by scrolling the touch sensor.
 Initial value: 50% (1500rpm)
 Adjustment  range:  OFF,  0~110%  (OFF,

700~3500rpm)

*When  the  RTN  button  is  touched  for  one  second,  the 

sensitivity is reset to the initial value.)

 Touch the RTN button to return to the cursor

mode.

 Move the cursor to the UNIT item and touch

the RTN button to switch to the data input

mode. Select the unit by scrolling the touch

sensor.

 Touch  the  RTN  button  to  change  the

operation mode and return  to the cursor

mode.