Manualsbrain.com
  1. Manuals
  2. Brands
  3. TP-LINK
  4. Single Parallel Port Fast Ethernet Print Server
  5. User Manual

TP-LINK Single Parallel Port Fast Ethernet Print Server TL-PS110P User Manual

Product codes
TL-PS110P
Download
Page of 60
TL-PS110P
Single Parallel Port Fast Ethernet Print Server
 
50 
installing the print server."   
Regarding this problem, there are three possible causes: 
A.  The print server's Node ID you specified in the "arp" command is not correct.                                           
If this is the case, please ensure the Node ID field in the corresponding entry of the print server's 
IP address in NT's ARP cache table is correct by typing the following command at NT's DOS 
prompt. "arp -a" 
If the Node ID shown on the screen doesn't match the print server's Node ID, please follow the 
instructions below to reset the entry. 
1. At NT's DOS prompt, type "arp -d <print server's IP address>" to delete the current entry. 
2. Type "arp -s <print server's IP> <print server's Node ID>" to specify a new ARP entry. 
3. Refer to Chapter 7 for the detailed instructions to complete the installation. 
B.  The print server's IP address is duplicated or is as same as another computer's IP 
address on the network.   
If this is the case, please consult your network administrator to obtain an unused IP address for 
your print server. 
C.  The print server is on one segment and your Windows NT server is on the other 
segment.                                                                                             
(This troubleshooting guide will also apply to a multiple-segmented network while installing the print 
server) 
For example, assuming the print server is on Segment A, NT server is on Segment B, and there is 
a gateway computer between Segment A and Segment B. The network might be a complete 
TCP/IP network, or a hybrid of TCP/IP and IPX/SPX network. 
If this is the case, you have to adopt the following steps, depending on which platform the gateway 
computer is. 
a. If the gateway computer is a NT/UNIX server: 
You have to do the same "arp" command to specify an entry on the NT/UNIX computer as a 
gateway in order for it to forward your subsequent "ping" or/and "tftp" commands to the print 
server. 
b. If the gateway computer is a Novell NetWare file server: 
1. Due to the presence of this NetWare file server, the IPX/SPX protocol might be used on 
your network. Therefore, we strongly suggest you run the PSAdmin from any client 
computer and select "Manual Setup" to specify the print server's IP address (For more 
detailed information about Manual Setup, please refer to Chapter 3).