Kathrein UFS 924sw/500GB/CI+ 20210209 User Manual
Product codes
20210209
4
Product return/original packaging
Make sure that the fan at the rear of the unit and the ventilation slots on the unit are
not blocked or covered in any way. The unit may otherwise overheat. Adjust the fan
speed to the temperature conditions in the receiver.
not blocked or covered in any way. The unit may otherwise overheat. Adjust the fan
speed to the temperature conditions in the receiver.
There is a risk of fi re!
You must not disconnect the receiver from the mains while it is in operation!
This can lead to a loss of data and corruption of the software.
This can lead to a loss of data and corruption of the software.
Safety instructions - important notes
Please keep the original packaging in case you need to return the product at any time. The receivers are
fragile due to their construction and are only adequately protected by the original packaging. If the receiver
is not shipped correctly the guarantee/warranty on it will be voided.
Before you disconnect the receiver from the mains, you must switch it to the standby mode by pressing the
standby button (on/off) on the remote control. In standby mode, any changed or new data that are broadcast
will be saved by the receiver. As soon as the receiver is in the standby mode, it can be disconnected from
the mains at any time.
The information in these operating instructions was correct at the time of going to print. W
e reserve
the right however to make changes at any time and without prior notice. If new software is released for
your receiver, and this af fects the information in the operating instructions (e.g. changes to the menus
and/or functions), and if we believe it necessary we will make new operating Instructions available for
download on “www.kathrein.de”.
Make a note of the receiver's basic settings (these are set during f rst installation) so you can restore them
if necessary!
Please be aware of your responsibility towards your fellow human beings. Keep these instructions
for any questions that arise later, and if the receiver passes to another owner, pass them on to the
new owner.
for any questions that arise later, and if the receiver passes to another owner, pass them on to the
new owner.
Instructions on how to set the fan can be found in the section “Mainmenu”, “Settings”, “Basic Settings”,
“Fan Control”.
Fan/ventilation slots on the unit
Switching the receiver off
Other
Warning!