Graupner Hendheld RC 2.4 GHz No. of channels: 12 33124 Data Sheet

219

remains controllable when the SUMO satellite 
receiver no longer receives a signal.
Telemetry data, such  as the voltage of the onboard 
electricity supply, on the other hand, is only sent to 
the transmitter by the satellite receiver confi gured 
as SUMO. Therefore, telemetry sensors are to be 
connected to the satellite receiver (SUMO).
Each receiver should be connected with its own 
supply line from the common voltage supply. With 
receivers with a high current load, it may even be 
benefi cial to connect them with two supply lines to 
the same current supply. 
On the other hand, if each of the two receivers 
should be supplied from 
its own voltage source, 
the center cable must 
be removed from one of 
the two plugs of the sat-
ellite cable; see fi gure.

red

1

2

3

If you would like to carry out additional programming, 
such as  fail-safe settings, disconnect the three-
pole satellite connection between the two receivers 
and switch on only the relevant receiver. It may be 
necessary to also change the connection sequence.