Buffalo LinkStation 441D 12TB LS441D1204-EU Data Sheet

83

behavior will be corrected in a future firmware update.

To save energy, you can specify times to put the LinkStation into sleep (standby) mode, where the hard drive and 
LEDs are turned off.

In Advanced Settings, click Management.

Click 

 to the right of "Sleep Timer".

Click Edit.

Specify the timer interval, wake-up time, and time to go into sleep mode, then click OK.

Notes: 
•  Up to three timers can be set.
•  The time to enter sleep mode can be set from 0:00 am to 3:45 of the next day.

The time to wake from sleep mode can be set from 0:00 to 23:45.
If the time to enter sleep mode is after 24:00, the wake-up time setting may be from 4:00 am to 23:45.

•  The time to enter sleep mode should not be set at the same time as or before the wake-up time.
•  If a backup job is scheduled during a disk check, disk format, backup job or within 5 minutes of the current 

time, the LinkStation will not change to standby mode when the time to enter sleep mode is reached.

•  If the scheduled times in the timer overlap, operation is performed using the widest time interval.
•  Examples of multiple timer settings are shown below.

Example 1:
If running at a current time of 10:00 Wednesday
Timer 1: Daily 12:00–24:00
Timer 2: Not used
Timer 3: Not used
No operation is performed at 12:00 and the unit goes into sleep mode at 24:00.
Example 2:
When running at a current time of 10:00 Wednesday
Timer 1: Daily 9:00–18:00