Danalock Smart lock Bluetooth-version 831957 Data Sheet
Product codes
831957
Inhaltsverzeichnis
Remove the old thumb turn on your
door, but please keep the screws that
held it for later use.
In the box you will find 2 tailpiece
extenders for flat and square
tailpieces, making your danalock
fit most deadbolts.
Now fasten the baseplate
with the screws that original
ly held the thumb turn and
cylinder piece.
Important! The cylinder tailpiece have to align with the
door surface. Extend the tailpiece with one of the two
extenders before you mount the baseplate. The tailpiece
extender should stick out 10 mm from the baseplate.
Click the lid off your danalock with your
nails, or loosen the lid by gently turning
a screwdriver in the slot at the rim of
the shell.
Place your danalock on the base, be
sure the cylinder tailpiece fits in the
center.
Fasten the 3 base-screws.
Click the lid back on. Now Your
danalock is now ready for use.
10 mm
align with
the door
surface
The danalock comes with batteries inserted, but a thin plastic folio
guarantee that your new danalock is fully charged. Remove the folio
and the danalock lits up with a green light for 5-10 seconds.
Loosen the 3 base-screws placed right underneath the
printed circuit board with a screwdriver.
Entfernen des
alten Türschlosses
Zunächst müssen
Zunächst müssen
Sie das alte Türschloss,
Zylinder und falls
vorhanden den Knauf
entfernen.(a)
Lösen Sie dazu
Lösen Sie dazu
die Befestigungs-
schraube unterhalb
des Türriegels und
ziehen Sie sie heraus (b)
02
Entfernen des alten Türschlosses
15 mm
MAX
15 mm
15 mm
MAX
15 mm
(b)
(a)
(Bei manchen Türen ist es
hilfreich, einen Streifen Klebe-
band über die Vorderseite des
Schlosses zu kleben.
Dadurch wird verhindert, dass
es herunterfällt, wenn die
Schrauben entfernt werden.)